Neoview Messages Manual (Volume 2) (R2.5)

Recovery Specify the name of a rule other than one of the predefined system rules, and then
retry the command.
[WMS]Programming exception: ComExecDirect, Cannot associate pre-defined
service
Cause You tried to associate one of the predefined system services, which begins with the
reserved “HPS_” prefix, with a rule.
Effect The ALTER WMS CONN or ALTER SERVICE COMP or EXEC command fails to
associate the rule with the service.
Recovery Specify the name of a service other than one of the predefined system services,
and then retry the command.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Cannot connect to WMS
Cause You issued a WMS command, and the WMS ZQSDLL could not identify a WMS
process on any of the segments during a FastExecDirect() call.
Effect The command fails.
Recovery Contact your HP service representative.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Cannot delete HP_DEFAULT_SERVICE
Cause You tried to delete HP_DEFAULT_SERVICE, which is disallowed.
Effect The operation fails.
Recovery You are prohibited from deleting HP_DEFAULT_SERVICE.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Cannot delete SYSTEM
Cause You tried to delete the SYSTEM service, which is disallowed.
Effect The operation fails.
Recovery You are prohibited from deleting the SYSTEM service.
[WMS]Programming exception: ComExecDirect, Cannot specify NO-ACTION
without a Warn level
Cause You specified NO-ACTION without specifying a warning level other than NO-WARN
in an ALTER RULE command.
Effect The ALTER RULE command does not modify the rule.
Recovery Specify a warning level other than NO-WARN in the ALTER RULE command,
and then retry the command.
[WMS]Programming exception: ComExecDirect, Cannot specify NO-WARN without
an action
Cause You specified NO-WARN without also specifying a rule action, such as REJECT,
HOLD, or CANCEL, in an ADD or ALTER RULE command.
Effect The ADD or ALTER RULE command does not modify the rule.
Recovery Specify a rule action in the ADD or ALTER RULE command, and then retry the
command.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = comment is greater than 256 characters
Cause You specified a comment that is greater than 256 characters in length, including spaces.
92 Neoview Workload Management Services (WMS) Messages