Neoview Messages Manual (Volume 2) (R2.5)

2 Neoview Workload Management Services (WMS)
Messages
This section describes Neoview Workload Management Services (WMS) error messages.
Unexpected programming exception: error=14, error_detail=0,
process=\segment-name.$ZWMGR,function=FILENAME_TO_PROCESSHANDLE_. Check
the server event log on node IP-address for details.
Cause You tried to use WMS before starting WMS.
Effect The operation fails.
Recovery Start WMS before using it. For more information, see the WMS chapter in the
Neoview Database Support Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = alias is greater than 50 characters
Cause You specified an alias that is greater than 50 characters in length.
Effect The operation fails.
Recovery Retry the operation with a valid alias that is 50 characters or less. For more
information, see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Cannot add SYSTEM
Cause You tried to add a service named SYSTEM, which is disallowed.
Effect The operation fails.
Recovery Retry the operation and specify a service name other than SYSTEM. For more
information, see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Cannot alter HP_DEFAULT_SERVICE active time
Cause You tried to alter the active time of the HP_DEFAULT_SERVICE service, which is
disallowed.
Effect The operation fails.
Recovery Add a service that has that active time and associate your queries with that service.
For more information, see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Cannot alter HP_DEFAULT_SERVICE priority
Cause You tried to alter the priority of the HP_DEFAULT_SERVICE service, which is
disallowed.
Effect The operation fails.
Recovery Add a service that has that priority and associate your queries with that service.
For more information, see the Neoview Workload Management Services Guide.
[WMS]Programming exception: ComExecDirect, Cannot associate pre-defined
rule
Cause You tried to associate one of the predefined system rules, which begins with the
reserved “HPS_” prefix, with a service.
Effect The ALTER WMS CONN or ALTER SERVICE COMP or EXEC command fails to
associate the rule with the service.
91