Neoview Messages Manual (Volume 1) (R2.5)

29406
Could not find the HP Neoview Type 4 driver in the classpath.
Cause The classpath for Neoview JDBC Type 4 Driver JAR file has not been set.
Effect Unable to launch the Neoview Command Interface.
Recovery Reinstall the Neoview Command Interface by selecting a valid Neoview JDBC
Type 4 Driver.
29407
Failed to connect to the database. Connection limit exceeded.
Cause The available database connections are already being used.
Effect Neoview Command Interface fails to connect to the database and start a new session.
Recovery Reconfigure the client data sources. For more information, see the Neoview
Database Administrator’s Guide.
29408
SET command must have an option specified
Cause You did not specify an option for the SET command.
Effect The SET command fails to execute.
Recovery Retry the SET command with an appropriate option. For more information, see
the Neoview Command Interface Guide.
29409
SHOW command must have an option specified.
Cause You did not specify an option for the SHOW command.
Effect The SHOW command fails to execute.
Recovery Retry the SHOW command with an appropriate option. For more information, see
the Neoview Command Interface Guide.
29410
Could not find the file specified.
Cause You specified an invalid/non-existing filename for the obey command.
Effect The obey command fails to execute.
Recovery Retry the OBEY command with a valid filename.
29412
This command is not supported in CS mode.
Cause You specified an interface command that is not supported in CS mode.
Effect The command fails to execute.
Recovery Retry the command by switching to the appropriate mode. Issue the help command
for more information on the list of supported commands in current mode.
29413
This command is not supported in NS mode.
Cause You specified an interface command that is not supported in NS mode.
Effect The command fails to execute.
368 Neoview Command Interface (NCI) Messages (29400 Through (29599)