Neoview Messages Manual (Volume 1) (R2.5)

Cause MXTOOL VERIFY found a constraint that is disabled.
Effect This is an informational message.
Recovery Contact your HP service provider to enable the constraint.
SQL 20853
20853 name is not an SQL/MX object that is supported by FIXUP. Only
TABLES, INDEXES and Materialized views are supported.
name
is the HP Neoview database object.
Cause You attempted to run the FIXUP utility on an HP Neoview database object that was
not a table, index, or materialized view.
Effect The operation fails.
Recovery Do not attempt to run the FIXUP utility on objects other than tables, indexes, and
materialized views. Enter a valid name and resubmit.
SQL 20858
20858 File file-name is located on a remote node. The current FIXUP
operation cannot be performed remotely.
file-name
is the HP Neoview platform file-name of the HP Neoview database object.
Cause You attempted to specify the FIXUP utility on a file that exists on a remote node
(Neoview platform segment).
Effect The operation fails.
Recovery You must run the FIXUP utility on the remote segment.
SQL 20859
20859 An internal FIXUP error occurred.
Cause An internal error occurred.
Effect The operation fails.
Recovery Do not attempt recovery. HP support will perform recovery operations in response
to an automatically generated dial-out message about this condition.
SQL 20861
20861 The corrupt bit has been reset for only local partitions of
file-name. Please execute the command on the remote nodes to update
respective remote partitions.
file-name
is the full name of the HP Neoview database object.
Cause This message is displayed whenever FIXUP is used with the -rc option on a table or
index with partitions on a remote node (Neoview segment).
Effect The corrupt bit is reset only on the local segment.
Recovery Do not attempt recovery. HP support will perform recovery operations in response
to an automatically generated dial-out message about this condition.
SQL 20862
20862 FIXUP can update the ANSI names for tables and Materialized views
only.
Cause You specified the -ra option on an object other than a table or materialized view.
Effect The operation fails.
Recovery Repeat the command with the correct syntax.
326 Utility Messages (20000 Through 23099)