Neoview Messages Manual (Volume 1) (R2.5)

Recovery Correct the syntax and resubmit.
SQL 8851
8851 A CLI Parameter bound check error occurred.
Cause The HP Neoview database software received a call-level interface (CLI) parameter
bound check error.
Effect The operation fails.
Recovery Do not attempt recovery. HP support will perform recovery operations in response
to an automatically generated dial-out message about this condition.
SQL 8852
8852 Holdable cursors are supported for only streaming cursors and
embedded update/delete cursors.
Cause You attempted to use a holdable cursor in a situation where it is not supported.
Effect The operation fails.
Recovery Do not attempt recovery. HP support will perform recovery operations in response
to an automatically generated dial-out message about this condition.
SQL 8853
8853 Specified attribute definition is not valid.
Cause You specified an invalid attribute definition.
Effect The operation fails.
Recovery Do not attempt recovery. HP support will perform recovery operations in response
to an automatically generated dial-out message about this condition.
SQL 8854
8854 Specified attribute value is not valid.
Cause You specified an invalid attribute value.
Effect The operation fails.
Recovery Do not attempt recovery. HP support will perform recovery operations in response
to an automatically generated dial-out message about this condition.
SQL 8855
8855 Statement attribute cannot be set now.
Cause You attempted to set a statement attribute after a statement was compiled. The attribute
must be set before compilation.
Effect The operation fails.
Recovery Correct the syntax and resubmit.
SQL 8856
8856 Specified attribute value is not valid. INPUT_ARRAY_MAXSIZE must
be positive.
Cause You specified an invalid attribute value. INPUT_ARRAY_MAXSIZE must be positive.
Effect The operation fails.
Recovery Do not attempt recovery. HP support will perform recovery operations in response
to an automatically generated dial-out message about this condition.
213