Neoview Command Interface (NCI) Guide (R2.5)

log c:\errorCode.log
select * from employee;
quit if errorcode=4082
log off
These results are logged when error code 4082 occurs:
SQL>select * from employee;
*** ERROR[4082] Table, view or stored procedure NEO.USR.EMPLOYEE
does not exist or is inaccessible.
SQL>quit if errorcode=4082
RECONNECT Command
The RECONNECT command creates a new connection to the Neoview platform using the login
credentials of the last successful connection.
Syntax
RECONNECT
Considerations
The host name or IP address and port number, credentials (user name and password) and the
datasource names values are used from information previously entered. This is the information
specified at launch or when the last CONNECT command was executed.
If NCI was invoked with the -noconnect launch parameter, NCI prompts you for the values.
Examples
This command creates a new connection to the Neoview platform using the login credentials of
the last successful connection:
SQL>reconnect
Connected to DataSource TDM_Default_DataSource
REPEAT Command
The REPEAT command reexecutes a previous command.
Syntax
REPEAT [ text | [-]number ]
text
specifies the text of the most recently executed command. The command must have been
executed beginning with text, but text need be only as many characters as necessary to
identify the command. NCI ignores leading blanks.
[-]number
is an integer that identifies a command in the history buffer. If number is negative, it indicates
the position of the command in the history buffer relative to the current command; if number
is positive, it is the ordinal number of a command in the history buffer.
The HISTORY command displays the commands or statements in the history buffer. See the
“HISTORY Command” (page 89).
RECONNECT Command 103