README for the HP Neoview Performance Analysis Tools (Upd1 R2.4 SP1)

When Uninstall HP Neoview Performance Analysis Tools is selected, a window is displayed
that shows the progress of the uninstallation process. When the window closes, the uninstallation
is complete.
Reinstalling the HP Neoview Performance Analysis Tools
To reinstall Neoview Performance Analysis Tools, HP recommends that you uninstall Neoview
Performance Analysis Tools and then install the new version. See “Installation Instructions”
(page 6) for instructions on installing Neoview Performance Analysis Tools.
Configuring and Using the Neoview Query Viewer
This section describes how to configure and use the Neoview Query Viewer.
Using the Neoview Query Viewer
After installation and configuration are complete, you can run or launch the Neoview Query
Viewer by either clicking on the shortcut icon placed on the desktop or by selecting Start > All
Programs > HP Neoview Performance Analysis Tools > Neoview Query Viewer. Depending
on the Neoview release you are using, the default list of columns can be different. This view of
the Neoview Query Viewer shows default columns for Release 2.3:
Connect to the previously configured client-side ODBC data source either by pressing the F5
key or selecting the Workspace menu Connect option. On Release 2.3 or later platforms, make
sure that you connect to the data source that was previously configured by HP Support to use
the service HP_QMGMT_SERVICE. When you are connected to the Neoview platform, the
Neoview Query Viewer automatically downloads a list of currently running queries and refreshes
itself on a pre-configured interval basis (the default is every 30 seconds for Release 2.3 or later
platforms and five minutes for Release 2.2 platforms).
Configuring Neoview Query Viewer Options
To customize the Neoview Query Viewer options, use the Tools > Options menu to adjust the
settings. From the Options menu, you can set the following options:
ControlsThis option...
The number of seconds to wait for establishing a connection.Connection Timeout
The number of seconds to wait when executing any command. The default value is
600 (seconds). To ensure that query management actions execute correctly, do not set
this value to a value lower than 600.
Command Timeout
Whether times are displayed in the local client time zone or in the time zone where
the Neoview platform resides.
Show times in local time
zone
8