README for HP Neoview Release 2.4 Service Pack 1

51018
Exception encountered while reading template file: template-file
exception
Cause An error occurred while reading the template file. Neoview Transporter might not
have permission to access the template file.
Effect The Control File Generator terminates.
Recovery Check the template file, and rerun the Control File Generator. If the problem
persists, contact HP Support and report this condition.
Neoview WMS Messages
[WMS]Programming exception: ComExecDirect, Service service-name is
outside the active time
Cause You tried to release a service named service-name that is outside of its active time.
Effect The RELEASE SERVICE command fails to release the service from the HOLD state.
Recovery Either wait until the active time of the service occurs or change the active time of
the service to the current time, and then retry the RELEASE SERVICE command.
[WMS]Programming exception: ComExecDirect, Cannot specify NO-WARN without
an action
Cause You specified NO-WARN without also specifying a rule action, such as REJECT,
HOLD, or CANCEL, in an ADD or ALTER RULE command.
Effect The ADD or ALTER RULE command does not modify the rule.
Recovery Specify a rule action in the ADD or ALTER RULE command, and then retry the
command.
[WMS]Programming exception: ComExecDirect, Cannot specify NO-ACTION
without a Warn level
Cause You specified NO-ACTION without specifying a warning level other than NO-WARN
in an ALTER RULE command.
Effect The ALTER RULE command does not modify the rule.
Recovery Specify a warning level other than NO-WARN in the ALTER RULE command,
and then retry the command.
[WMS]Programming exception: ComExecDirect, Cannot associate pre-defined
rule
Cause You tried to associate one of the predefined system rules, which begins with the
reserved “HPS_” prefix, with a service.
Effect The ALTER WMS CONN or ALTER SERVICE COMP or EXEC command fails to
associate the rule with the service.
Recovery Specify the name of a rule other than one of the predefined system rules, and then
retry the command.
[WMS]Programming exception: ComExecDirect, Cannot associate pre-defined
service
Cause You tried to associate one of the predefined system services, which begins with the
reserved “HPS_” prefix, with a rule.
Effect The ALTER WMS CONN or ALTER SERVICE COMP or EXEC command fails to
associate the rule with the service.
New Features for Release 2.4 SP1 19