Neoview Workload Management Services Guide (R2.4)

Table A-1 WMS Commands (continued)
See these WMS commands:To perform these tasks:
• “STATUS SERVICE COMP Command” (page 144)
(or “INFO SERVICE COMP Command” (page 121))
• “STATUS SERVICE EXEC Command” (page 145)
(or “INFO SERVICE EXEC Command” (page 122))
• “STATUS SERVICE RULE Command” (page 146)
• “STATUS WMS CONN Command” (page 150)
(or “INFO WMS CONN Command” (page 124))
To display the associations of rules with
services:
Chapter 5: Managing Workload
• “ALTER WMS RESET STATS Command” (page 109)
• “STATUS SERVICE SEGMENT STATS Command” (page 147)
• “STATUS WMS SEGMENT STATS Command” (page 151)
To display aggregated statistics about the
queries running in WMS:
• “STATUS QUERY Command” (page 136)
• “STATUS QUERIES Command” (page 127)
To monitor a query or a set of queries in
WMS:
• “CANCEL Command” (page 110)
• “HOLD Command” (page 113)
• “RELEASE Command” (page 125)
To cancel, put on hold, or release a query or
a set of queries:
82 WMS Commands