Neoview Workload Management Services Guide (R2.4)

A WMS Commands
NOTE: Administrators are permitted to run any WMS command. By default, administrators
include ROLE.DBA and the super IDs, super.services and super.super. Users other than
administrators may execute only these commands:
• INFO WMS
• STATUS QUERIES
• STATUS QUERY
• STATUS WMS
Table A-1 WMS Commands
See these WMS commands:To perform these tasks:
Chapter 2: Getting Started
• “STATUS WMS VERSION Command” (page 152)To display version information for WMS:
Chapter 3: Configuring Services
• “ADD SERVICE Command” (page 91)
• “ALTER SERVICE Command” (page 101)
• “DELETE SERVICE Command” (page 112)
To add, alter, or delete services:
• “STATUS SERVICE Command” (page 142)
(or “INFO SERVICE Command” (page 119))
To display the defined attributes of services:
• “STOP SERVICE Command” (page 153)
• “START SERVICE Command” (page 126)
To stop or start a service:
• “ALTER WMS Command” (page 106)
• “STATUS WMS Command” (page 149)
(or “INFO WMS Command” (page 123))
To alter or display the WMS system
configuration:
Chapter 4: Configuring Rules
• “ADD RULE CONN Command” (page 86)
• “ADD RULE COMP Command” (page 83)
• “ADD RULE EXEC Command” (page 88)
• “ALTER RULE CONN Command” (page 97)
• “ALTER RULE COMP Command” (page 94)
• “ALTER RULE EXEC Command” (page 99)
• “DELETE RULE Command” (page 111)
To add, alter, or delete rules:
• “STATUS RULE Command” (page 138)
(or “INFO RULE Command” (page 115))
• “STATUS RULE CONN Command” (page 140)
(or “INFO RULE CONN Command” (page 117))
• “STATUS RULE COMP Command” (page 139)
(or “INFO RULE COMP Command” (page 116))
• “STATUS RULE EXEC Command” (page 141)
(or “INFO RULE EXEC Command” (page 118))
To display the defined attributes of rules:
• “ALTER SERVICE COMP Command” (page 104)
• “ALTER SERVICE EXEC Command” (page 105)
• “ALTER WMS CONN Command” (page 108)
To associate rules with a service:
81