Neoview Workload Management Services Guide (R2.4)

B New and Changed Information
This appendix describes new WMS functionality for Neoview Release 2.4 and explains the
differences in WMS functionality between releases 2.3 and 2.4.
• “What Is New for This Release” (page 155)
• “What Changed for This Release” (page 156)
What Is New for This Release
The following functionality is new for this release:
• Rules mechanism (CONN for connection mapping, COMP for compilation rules, and EXEC
for execution rules). For more information, see Chapter 4 (page 39).
• New WMS commands:
Table B-1 New WMS Commands for Neoview Release 2.4
New WMS CommandsFunction
— “ADD RULE CONN Command” (page 86)
— “ADD RULE COMP Command” (page 83)
— “ADD RULE EXEC Command” (page 88)
— “ALTER RULE CONN Command” (page 97)
— “ALTER RULE COMP Command” (page 94)
— “ALTER RULE EXEC Command” (page 99)
— “DELETE RULE Command” (page 111)
To add, alter, or delete rules:
— “STATUS RULE Command” (page 138)
(or “INFO RULE Command” (page 115))
— “STATUS RULE CONN Command” (page 140)
(or “INFO RULE CONN Command” (page 117))
— “STATUS RULE COMP Command” (page 139)
(or “INFO RULE COMP Command” (page 116))
— “STATUS RULE EXEC Command” (page 141)
(or “INFO RULE EXEC Command” (page 118))
To display the defined attributes of rules:
— “ALTER SERVICE COMP Command” (page 104)
— “ALTER SERVICE EXEC Command” (page 105)
— “ALTER WMS CONN Command” (page 108)
To associate rules with a service:
— “STATUS SERVICE COMP Command” (page 144)
(or “INFO SERVICE COMP Command”
(page 121))
— “STATUS SERVICE EXEC Command” (page 145)
(or “INFO SERVICE EXEC Command” (page 122))
— “STATUS SERVICE RULE Command” (page 146)
— “STATUS WMS CONN Command” (page 150)
(or “INFO WMS CONN Command” (page 124))
To display the associations of rules with services:
— “START SERVICE Command” (page 126)
— “STOP SERVICE Command” (page 153)
To start or stop a service:
What Is New for This Release 155