Neoview Workload Management Services Guide (R2.4)

STATUS SERVICE Command
The STATUS SERVICE command returns information about the attributes of one or all services
in WMS.
NOTE: Only administrators are permitted to run this command. By default, an administrator
is ROLE.DBA or the super ID (super.services or super.super).
Syntax
STATUS SERVICE [ { service-name | ALL } ]
service-name
is the name of a user-defined service for managing queries. service-name can be a maximum
of 24 characters and must be a unique name in WMS. service-name must exist in the WMS
configuration but cannot be the SYSTEM service. The service name is not case-sensitive and
is always converted to uppercase. WMS supports multibyte characters in the service name.
For guidelines on using multibyte character sets, see the Neoview Character Sets Administrator's
Guide. For output information, see Table A-21 (page 143).
ALL
returns status information about all the services in WMS.
142 WMS Commands