Neoview Workload Management Services Guide (R2.4)

START SERVICE Command
The START SERVICE command starts a service and sets the state of the service to ACTIVE. Use
this command after issuing a STOP SERVICE command.
NOTE: Only administrators are permitted to run this command. By default, an administrator
is ROLE.DBA or the super ID (super.services or super.super).
Syntax
START SERVICE service-name
service-name
is the name of a user-defined service for managing queries. service-name can be a maximum
of 24 characters and must be a unique name in WMS. service-name must exist in the WMS
configuration but cannot be the SYSTEM service. The service name is not case-sensitive and
is always converted to uppercase. WMS supports multibyte characters in the service name.
For guidelines on using multibyte character sets, see the Neoview Character Sets Administrator's
Guide.
Examples
• This command starts SERVICE1:
START SERVICE SERVICE1;
126 WMS Commands