Neoview Messages Manual (Volume 2) (R2.4)

Effect The operation fails.

Recovery You are prohibited from deleting HP_DEFAULT_SERVICE.

Unexpected programming exception: ComExecDirect: exception detail = 0,

error message = Cannot delete SYSTEM

Cause You tried to delete the SYSTEM service, which is disallowed.

Effect The operation fails.

Recovery You are prohibited from deleting the SYSTEM service.

Unexpected programming exception: ComExecDirect: exception detail = 0,

error message = Use INFO WMS

Cause You specified SYSTEM for the service in an INFO SERVICE command, which is

disallowed.

Effect The operation fails.

Recovery Retry by using the INFO WMS command. For more information, see the Neoview

Workload Management Services Guide.

Unexpected programming exception: ComExecDirect: exception detail = 0,

error message = Use HOLD WMS

Cause You specified SYSTEM for the service in a HOLD SERVICE command, which is

disallowed.

Effect The operation fails.

Recovery Retry by using the HOLD WMS command. For more information, see the Neoview

Workload Management Services Guide.

Unexpected programming exception: ComExecDirect: exception detail = 0,

error message = Use RELEASE WMS

Cause You specified SYSTEM for the service in a RELEASE SERVICE command, which is

disallowed.

Effect The operation fails.

Recovery Retry by using the RELEASE WMS command. For more information, see the

Neoview Workload Management Services Guide.

Unexpected programming exception: ComExecDirect: exception detail = 0,

error message = SEGMENT must be greater than 0

Cause You specified 0 for the segment in the STATUS MEMORY command.

Effect The operation fails.

Recovery Retry the operation and specify a segment greater than 0. For more information,

see the WMS chapter in the Neoview Database Support Guide.

Unexpected programming exception: ComExecDirect: exception detail = 0,

error message = For this command WMS must be running on primary segment

Cause You issued a WMS command, and the WMS ZQSDLL could not find an executing

WMS process on the primary segment (that is, segment 1).

Effect The command fails.

Recovery Contact your HP service representative.

Unexpected programming exception: ComExecDirect: exception detail = 0,

error message = Cannot connect to WMS