Neoview Messages Manual (R2.3)

Cause Error 11033 or Error 11034 gives the cause for failure in decoding the string.
Effect Encryption tool exits without executing the requested operation.
Recovery Correct the failure cause, and retry. If the problem persists, contact your HP service
provider.
11029
Entry with reference name <ref-name> already exists in file <file>
Cause Reference name argument specified for option -r (during add operation) is already
present in the file encctlprops.txt.
Effect Encryption tool exits without executing the add operation.
Recovery Specify an unused reference name.
11030
File open in read mode failed. File = <file>
Cause Opening of file in read mode failed.
Effect Encryption tool exits without executing the requested operation.
Recovery Depends on the reason for the failure.
11031
File open in write mode failed. File = <file>
Cause Opening of file in write mode failed.
Effect Encryption tool exits without executing the requested operation.
Recovery Depends on the reason for this failure.
11033
The length of the encoded string is invalid. Encoded string = <string>
Cause The Base 64 encoded string has an invalid length. This is because the encoded string
stored in file props.txt or encctlprops.txt has been tampered.
Effect Encryption tool exits without executing the requested operation.
Recovery If the reported string is site key or message digest of site key, then re-install
encryption module. If the reported string is encrypted plaintext word, then delete that entry
from encctlprops.txt and encrypt it again.
11034
Characters in encoded string are invalid. Encoded string = <string>
Cause The Base 64 encoded string has an invalid character. This is because the encoded
string stored in the file props.txt or encctlprops.txt has been tampered.
Effect Encryption tool exits without executing the requested operation.
Recovery If the reported string is site key or message digest of site key, then re-install
encryption module. If the reported string is encrypted plaintext word, then delete that entry
from encctlprops.txt and encrypt it again.
13001
Option = <option> is not supported, controlfile = <cf>
Cause Option name was not recognized.
Effect The client stops processing the control file.
363