Neoview Owner's Manual (R2.2)

Product in accordance with US FDA regulations and the IEC 60825-1. The product does not emit
hazardous laser radiation.
WARNING: Use the controls or adjustments or performance of procedures other than
those specified herein or in the laser product’s installation guide may result in hazardous
radiation exposure. To reduce the risk of exposure to hazardous radiation:
• Do not try to open the module enclosure. There are no user-serviceable components
inside.
• Do not operate controls, make adjustments, or perform procedures to the laser device
other than those specified herein.
• Allow only HP Authorized Service technicians to repair the module.
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration
implemented regulations for laser products on August 2, 1976. These regulations apply to laser
products manufactured from August 1, 1976. Compliance is mandatory for products marketed
in the United States.
SAFETY CAUTION
The following icon or caution statements may be placed on equipment to indicate the presence
of potentially hazardous conditions:
DUAL POWER CORDS CAUTION: “THIS UNIT HAS MORE THAN ONE POWER
SUPPLY CORD. DISCONNECT ALL POWER SUPPLY CORDS TO COMPLETELY
REMOVE POWER FROM THIS UNIT." "ATTENTION: CET APPAREIL COMPORTE
PLUS D'UN CORDON D'ALIMENTATION. DÉBRANCHER TOUS LES CORDONS
D'ALIMENTATION AFIN DE COUPER COMPLÈTEMENT L'ALIMENTATION DE
CET ÉQUIPEMENT". DIESES GERÄT HAT MEHR ALS EIN NETZKABEL. VOR DER
WARTUNG BITTE ALLE NETZKABEL AUS DER STECKDOSE ZIEHEN.
Any surface or area of the equipment marked with these symbols indicates the presence
of electric shock hazards. The enclosed area contains no operator-serviceable parts.
WARNING: To reduce the risk of injury from electric shock hazards, do not open this
enclosure.
NOT FOR EXTERNAL USE
CAUTION: NOT FOR EXTERNAL USE. ALL RECEPTACLES ARE FOR INTERNAL USE ONLY.
ATTENTION: NE PAS UTILISER A L’EXTERIEUR DE L’EQUIPEMENT
IMPORTANT: TOUS LES RECIPIENTS SONT DESTINES UNIQUEMENT A UN USAGE
INTERNE.
VORSICHT: ALLE STECKDOSEN DIENEN NUR DEM INTERNEN GEBRAUCH.
HIGH LEAKAGE CURRENT
To reduce the risk of electric shock due to high leakage currents, a reliable grounded (earthed)
connection should be checked before servicing the power distribution unit (PDU).
Observe the following limits when connecting the product to AC power distribution devices:
For PDUs that have attached AC power cords or are directly wired to the building power, the
total combined leakage current should not exceed 5 percent of the rated input current for the
device.
51