Neoview Messages Manual (R2.2)

TCP/IP Writer Thread, Load Task-Specific Messages
Invalid port for connection
Cause An invalid (negative) port number was supplied by the gelserver on the Neoview
platform.
Recovery This is an internal error. Retry the load task. If the problem persists, contact the
GMCSC for analysis of accompanying error and warning messages.
Invalid connection parameters
Cause An invalid port number was supplied by the gelserver on the Neoview platform.
Recovery This is an internal error. Retry the load task. If the problem persists, contact the
GMCSC for analysis of accompanying error and warning messages.
Invalid IP address for connection. Error number = error.
error is the value of the errno variable returned by TCP/IP.
Cause An invalid IP address was supplied by the gelserver on the Neoview platform.
Recovery This is an internal error. Retry the load task. If the problem persists, contact the
GMCSC for analysis of accompanying error and warning messages.
Socket creation failure. Error number = error.
error is the value of the errno variable returned by TCP/IP.
Cause Failed to create TCP/IP socket. Possibly problems occurred in TCP/IP on the Linux
system.
Recovery Contact the GMCSC for analysis of accompanying error and warning messages.
Connection to loader failed. Check if loader has been started. Error
number = error.
error is the value of the errno variable returned by TCP/IP.
Cause Failed to connect to a gelserver on the Neoview platform. Possibly:
• The gelserver process on the Neoview platform terminated before accepting the connection.
• Various problems occurred in the network between the Neoview platform and Linux
system.
Recovery Contact the GMCSC for analysis of accompanying error and warning messages.
Message could not be sent to the loader. Error number = error.
error is the value of the errno variable returned by TCP/IP.
Cause Failed to send message to a gelserver on the Neoview platform. Possibly:
• The gelserver process on the Neoview platform terminated.
• Various problems occurred in the network between the Neoview platform and Linux
system.
Cause Contact the GMCSC for analysis of accompanying error and warning messages.
Failure in sending message to the loader. Error number = error.
error is the value of the errno variable returned by TCP/IP.
Cause Failed to send all the data to a gelserver on the Neoview platform. Possibly problems
occurred in TCP/IP on the Linux system.
Recovery Contact the GMCSC for analysis of accompanying error and warning messages.
No reply from loader. Error number = error.
Linux Gelserver Messages 383