Neoview Messages Manual (R2.2)

Recovery Contact the GMCSC.
SQL 20818
20818 The refreshed_at defined on the label does not match the
refreshed_at defined in the metadata for Guardian file (file).
file
is the HP Neoview platform file being verified.
Cause An inconsistency was found during the VERIFY operation.
Effect This is an informational message. VERIFY found a problem that needs attention.
Recovery Contact the GMCSC.
SQL 20821
20821 Constraint constraint is disabled.
constraint
is the name of the constraint.
Cause MXTOOL VERIFY found a constraint that is disabled.
Effect This is an informational message.
Recovery Contact the GMCSC to enable the constraint.
SQL 20853
20853 name is not an SQL/MX object that is supported by FIXUP. Only
TABLES, INDEXES and Materialized views are supported.
name
is the HP Neoview database object.
Cause You attempted to run the FIXUP utility on an HP Neoview database object that was
not a table, index, or materialized view.
Effect The operation fails.
Recovery Do not attempt to run the FIXUP utility on objects other than tables, indexes, and
materialized views. Enter a valid name and resubmit.
SQL 20858
20858 File file-name is located on a remote node. The current FIXUP
operation cannot be performed remotely.
file-name
is the HP Neoview platform file-name of the HP Neoview database object.
Cause You attempted to specify the FIXUP utility on a file that exists on a remote node
(Neoview platform segment).
Effect The operation fails.
Recovery You must run the FIXUP utility on the remote segment.
SQL 20859
20859 An internal FIXUP error occurred.
Cause An internal error occurred.
Effect The operation fails.
Recovery Do not attempt recovery. HP support will perform recovery operations in response
to an automatically generated dial-out message about this condition.
SQL 20861
20861 The corrupt bit has been reset for only local partitions of
file-name. Please execute the command on the remote nodes to update
respective remote partitions.
282 Utility Messages (20000 Through 23099)