R2511-HP MSR Router Series Voice Configuration Guide(V5)
206
Ste
p
Command
Remarks
2. Enter voice view.
voice-setup N/A
3. Enter voice dial
program view.
dial-program N/A
4. Enter VoIP voice entity
view.
entity entity-number voip N/A
5. Bind a SIP trunk
account to the VoIP
voice entity.
bind sip-trunk account account-index
By default, no SIP trunk account is bound
to the VoIP voice entity.
Only an existing SIP trunk account can
be bound to a VoIP voice entity.
6. Enable the SIP proxy
server.
address sip proxy
Not configured by default.
7. Return to system view.
quit N/A
8. Enter SIP client view.
sip N/A
9. Specify a SIP server
group to be used as
the proxy server.
proxy { dns domain-name | ipv4
ip-address [ port port-number ] |
server-group group-number }
Not configured by default.
Configuring call match rules
You can control call route selection by configuring the prefix of the source host name, prefix of the
destination host name, or the source IP address as the call match rule in VoIP voice entity view. If you have
configured several call match rules, only the callings that match all rules are permitted. Configure the call
match rules as follows:
• Use the match source host-prefix command to specify the prefix of source host name as a call match
rule for a VoIP voice entity. The specified prefix of source host name is used to match against the
source host names of calls.
{ If the INVITE message received by the SIP trunk device carries the Remote-Party-ID header, the calling
information is abstracted from this header field.
{ If the INVITE message received by the SIP trunk device carries the Privacy header, the source host name is
abstracted from the P-Asserted-Identity or P-Preferred-Identity header field.
{ If the INVITE message received by the SIP trunk device does not carry any of the previously mentioned three
header fields, the host name in the From header field of the INVITE message is used as the source host name.
• Use the match destination host-prefix command to specify the prefix of destination host name as a
call match rule for a VoIP voice entity. The specified prefix of destination host name is used to match
against the destination host names of calls. The host name in the To header field of an INVITE
message received by the SIP trunk device is used as the destination host name.
• Use the match source address command to specify the source address as a call match rule for a
VoIP voice entity.
To configure the call match rules:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A