MSA7X Series Enclosure Midplane Replacement Instructions (436512-001, February 2007)

Installing the midplane
To install the midplane, reverse the removal procedure:
1. Insert the midplane into the chassis, making sure that it is
engaged with the backplane. Then press the lever down to
secure it in the chassis and connect the cables.
2. Install the riser board, 7-segment display board, I/O
module and blank, fans, and power supplies.
3. Install the access panel.
4. Insert the enclosure into the rack and power up the
enclosure.
Verifying component replacement
After replacing the midplane, check the following to verify the
component is operating normally:
• Hard drive status LEDs
• I/O module status LED
• Fan module status LED