HP StorageWorks 60 Modular Smart Array Enclosure Maintenance and Service Guide (405865-002, August 2007)

Removal and replacement procedures 27
9.
Slide the board back to remove it from the guide, and then lift it out of the chassis (5).
To replace the components, reverse the removal procedure.
Verifying proper operation
After replacing the component, verify proper operation using the following methods:
• Check the heartbeat LED and fault LED status ("Front panel LEDs and buttons" on page 34).
• Check the power supply LED status ("Rear panel LEDs and buttons" on page 35).
Power UID board
Verifying component failure
Before replacing the component, verify component failure using the following methods:
• Check the status LEDs ("Rear panel LEDs and buttons" on page 35).
• Check the host log for errors.
To remove the component:
1. Power down the storage enclosure (on page 19).
2. Remove the storage enclosure (on page 19).
3. Remove the access panel ("Access panel" on page 20).
4. Disconnect the cable from the midplane (1).
5. Remove the T-15 screw securing the board and bezel to the chassis (2).
6. Remove the LED bezel (3).