HP StorageWorks 60 Modular Smart Array Enclosure Maintenance and Service Guide (405865-002, August 2007)

Removal and replacement procedures 25
4.
Remove the module (3).
NOTE: Use this same procedure to remove an I/O blank.
To replace the component, reverse the removal procedure.
Verifying proper operation
After replacing the component, check the status LED.
Front UID board
Verifying component failure
Before replacing the component, check the status LED ("Front panel LEDs and buttons" on page 34).
To remove the components:
1. Power down the storage enclosure (on page 19).
2. Remove the plastic cover (1).
3. Remove the T-10 screw to release the board from the chassis (2).