HP StorageWorks 2300 Family Modular Smart Array CLI reference guide (500912-002, July 2010)

HP StorageWorks 2000 G2 Modular Smart Array CLI Reference Guide 143
show host-parameters
Description Shows information about host ports on both controllers.
Syntax
show host-parameters
Output Port
Host port number
Media
• FC(L): Fibre Channel-Arbitrated Loop
• FC(P): Fibre Channel Point-to-Point
• FC(-): Fibre Channel disconnected
• SAS: Serial Attached SCSI
• iSCSI: Internet SCSI
Target ID
Enclosure WWN or serial number
Status
• Up: Port is cabled and has an I/O link.
• Disconnected: Either no I/O link is detected or the port is not cabled.
Speed (A)
FC and SAS only. Actual link speed in Gbit/sec. Blank if not applicable.
Speed (C)
FC and SAS only. Configured link speed in Gbit/sec. Blank if not applicable.
Topo (C)
FC and SAS only. Configured topology.
PID
FC only. Primary ID. Blank if not applicable.
Width
SAS only. Number of SAS lanes configured for this port.
IP Ver
iSCSI only. IPv4
PIP
iSCSI only. Primary IP address
PIP-Netmask
iSCSI only. Primary subnet mask IP address
PIP-Gateway
iSCSI only. Primary gateway IP address
PIP-Service Port
iSCSI only. Service Port
Port-Name
iSCSI only. Target name for the port. The name is the storage system's IQN with the suffix .a for
ports on controller A or .b for ports on controller B.
Target Alias
iSCSI only. Target alias for the port. The alias is the storage system's name with the suffix .a for ports
on controller A or .b for ports on controller B.