HP StorageWorks 2300 Family Modular Smart Array CLI reference guide (500912-002, July 2010)

HP StorageWorks 2000 G2 Modular Smart Array CLI Reference Guide 109

set snmp-parameters

Description Sets SNMP parameters for event notification. To enable or disable SNMP requests to the MIB use the

set protocols command.

Syntax

set snmp-parameters

[enable crit|warn|info|none]

[add-trap-host address]

[del-trap-host address]

[trap-host-list trap-host-list]

[read-community string]

[write-community string]

Parameters enable crit|warn|info|none

Optional. Sets the level of trap notification:

• crit: Sends critical events only.

• warn: Sends all critical events and warnings.

• info: Sends all events.

• none: All events are excluded from trap notification and traps are disabled.

add-trap-host address

Optional. Specifies the IP address of a destination host to send traps to. Three trap hosts can be set.

del-trap-host address

Optional. Deletes a trap destination host.

trap-host-list trap-host-list

Optional. Replaces the current list.

read-community string

Optional. Sets an alphanumeric community string for read-only access.

write-community string

Optional. Sets an alphanumeric community string for write access.

Example Enable critical events only, specify a trap host, and set the community string for read-only access:

# set snmp-parameters enable crit add-trap-host 172.22.4.171 read-community

public

Success: Command completed successfully. - SNMP parameters were changed.