HP MSA 2040 CLI Reference Guide

416 XML API basetype properties
fan
This basetype is used by show fans.
Table 34 fan properties
Name Type Description
durable-id string Fan unit ID in the form fan_ enclosure-ID . fan-number .
name string Fan unit name in the form Fan loc: position -PSU power-supply-ID for
a controller enclosure or MSA 2040 drive enclosure; Fan
fan-unit-ID for a
D2700 enclosure. The position is as viewed from the back of the enclosure.
location string Fan location in the form Enclosure enclosure-ID - position . The
position is as viewed from the back of the enclosure.
status string Fan unit status.
• Up
• Error
• Off
• Unknown
status-numeric uint32 Numeric equivalents for status values.
• 0: Up
• 1: Error
• 2: Off
• 3: Unknown
speed uint32 Fan speed (revolutions per minute).
position string Fan position, as viewed from the back of the enclosure.
• Left
• Right
• Top
• Bottom
position-
numeric
uint32 Numeric equivalents for position values.
• 0: Left
• 1: Right
• 2: Top
• 3: Bottom
serial-number string • (blank): Not applicable.
• Serial number of a fan in a D2700 enclosure.
fw-revision string • (blank): Not applicable.
• Firmware revision of a fan in a D2700 enclosure.
hw-revision string • (blank): Not applicable.
• Hardware revision of a fan in a D2700 enclosure.
health string • OK
• Degraded
• Fault
• Unknown
health-numeric uint32 Numeric equivalents for health values.
• 0: OK
• 1: Degraded
• 2: Fault
• 4: Unknown