HP MSA 2040 CLI Reference Guide

show volumecopy-status 335
show volumecopy-status
Description Shows information about in-progress volume copy operations. While a volume copy is in progress,
the destination volume cannot be accessed.
Syntax
show volumecopy-status
[controller a|b|both]
Parameters controller a|b|both
Optional. Shows volume copy operations for volumes owned by controller A only, by controller B
only, or by either controller (both). If this parameter is omitted, all volume copy operations are
shown.
Output VC Volume Name
Destination volume name
Serial Number
Destination volume serial number
Vdisk
Destination vdisk name
Source Volume
Source volume name
Progress
Percent complete of the volume copy
Status
• VC Online: A volume copy is in progress to the destination volume.
• VC Offline: The source volume went offline while a volume copy was in progress. When the
source volume comes back online, the copy process resumes from the point where it stopped.
• Unknown: Status is unknown.
Status-Reason
More information about the Status value.
Example Show information about volume copies in progress for controller A:
# show volumecopy-status controller a
VC Volume Name Serial Number Vdisk Source Volume Progress Status
Status-Reason
--------------------------------------------------------------------------
MV1-copy
SN VD1 MV1 7% VC Online
VC In Progress
--------------------------------------------------------------------------
Success: Command completed successfully. (2014-01-01 17:14:05)
Basetypes • volume-copy-status
• status
See also • abort volumecopy
• volumecopy