HP MSA 2040 CLI Reference Guide

304
show snapshots
Description Shows information about snapshots for a specified controller, master volume, or snap pool. If no
parameters are specified, information about all snapshots is shown.
Syntax
show snapshots
[controller a|b|both]
[master-volume
volume ]
[snap-pool
volume ]
[type standard|replication|all]
Parameters controller a|b|both
Optional. Shows snapshots owned by controller A only, by controller B only, or by either controller
(both). If this parameter is omitted, snapshots owned by either controller are shown.
master-volume
volume
Optional. Shows snapshots associated with the specified master volume name or serial number. For
volume syntax, see "Command syntax" (page 20).
snap-pool
volume
Optional. Shows snapshots associated with the specified snap pool name or serial number. For
volume syntax, see "Command syntax" (page 20).
type standard|replication|all
Optional. Shows only standard (non-replication) snapshots, only replication snapshots, or snapshots
of all types. If this parameter is omitted, snapshots of all types are shown.
Output Vdisk
Vdisk name
Serial Number
Snapshot serial number
Name
Snapshot name
Creation Date/Time
Date and time the snapshot was prepared or committed
Status
• Available
• Unavailable: See the Status-Reason value.
Status-Reason
Shows N/A for Available status, or one of the following reasons for Unavailable status:
• snapshot not found
• snap pool not found
• master volume not found
• snapshot pending (not yet committed)
• snap pool not accessible
• master volume not accessible
• Volume copy with modified data is in progress
• Rollback with modified data is in progress
• Unknown reason
Source Volume
Name of the volume of which the snapshot was taken
Snap-pool Name
Snap pool name