HP MSA 2040 CLI Reference Guide

show expander-status 241

Disabled

• Enabled: PHY is enabled.

• Disabled: PHY is disabled.

Reason

• Blank if Elem Status is OK.

• Error count interrupts: PHY disabled because of error-count interrupts.

• Phy control: PHY disabled by a SES control page as a result of action by a Storage

Controller or user.

• Not ready: PHY is enabled but not ready. Appears for SC-1 PHYs when the partner I/O

module is not installed. Appears for Drive, SC-1, or Ingress PHYs when a connection problem

exists such as a broken connector.

• Drive removed: PHY disabled because drive slot is empty.

• Unused - disabled by default: PHY is disabled by default because it is not used.

• Excessive Phy changes: PHY is disabled because of excessive PHY change counts.

Example Show expander status for a 2U24 system:

# show expander-status

Encl Ctlr Phy Type Status Elem Status Disabled

Reason

-----------------------------------------------------------------------------

1 A 0 Drive Enabled - Healthy OK Enabled

1 A 1 Drive Disabled OK Disabled

Drive removed

...

-----------------------------------------------------------------------------

Encl Ctlr Phy Type Status Elem Status Disabled

Reason

-----------------------------------------------------------------------------

1 B 0 Drive Enabled - Healthy OK Enabled

1 B 1 Drive Disabled OK Disabled

Drive removed

...

-----------------------------------------------------------------------------

Success: Command completed successfully. (2013-07-31 15:02:13)

Basetypes • sas-status-controller-a

• status