HP MSA 2040 CLI Reference Guide

224
How Used
• AVAIL: Available
• FAILED: The disk is unusable and must be replaced. Reasons for this status include: excessive
media errors; SMART error; disk hardware failure; unsupported disk.
• GLOBAL SP: Global spare
• LEFTOVR: Leftover
• VDISK: Used in a vdisk
• VDISK SP: Spare assigned to a vdisk
Any jobs running on the disk or its vdisk follow the How Used value:
• DRSC: The disk is being scrubbed.
• EXPD: The vdisk is being expanded.
• INIT: The vdisk is being initialized.
• RCON: The vdisk is being reconstructed.
• VRFY: The vdisk is being verified.
• VRSC: The vdisk is being scrubbed.
Type
• SAS: Enterprise SAS
• SAS MDL: Midline SAS
• sSAS: SAS SSD
Job%
If a job is running, the percent complete.
Speed (kr/min)
The speed of a spinning disk, in thousands of revolutions per minute, as specified by the disk vendor.
For an SSD, 0 is shown.
Size
Disk capacity
Rate*(Gbit/s)
The data transfer rate in Gbit/s. A footnote indicates that it is normal behavior for the rate to vary.
Some 6-Gbit/s disks might not consistently support a 6-Gbit/s transfer rate. If this happens, the
controller automatically adjusts transfers to those disks to 3 Gbit/s, increasing reliability and
reducing error messages with little impact on system performance. This rate adjustment persists until
the controller is restarted or power-cycled.
SP
• A or B: A dual-ported disk is communicating through a single port to the connected controller. A
failure is preventing communication through the second port to the other controller.
• (Blank): The disk is operating normally.
Recon State
The state of the disk (source or destination) if it is involved in a reconstruct operation.
• From: This disk is being used as the source of a reconstruct operation.
• To: This disk is being used as the target of a reconstruct operation.
• N/A: This disk is not being used in a reconstruct operation.
Copyback State
• N/A: Not applicable.