HP MSA 2040 CLI Reference Guide

show debug-log-parameters 221
show debug-log-parameters
Description Shows which debug message types are enabled (On) or disabled (Off) for inclusion in the Storage
Controller debug log. For use by or with direction from technical support.
Syntax
show debug-log-parameters
Output • host: Host interface debug messages. Enabled by default.
• disk: Disk interface debug messages. Enabled by default.
• mem: Internal memory debug messages. Disabled by default.
• fo: Failover and recovery debug messages. Enabled by default.
• msg: Inter-controller message debug messages. Enabled by default.
• ioa: I/O interface driver debug messages (standard). Enabled by default.
• iob: I/O interface driver debug messages (resource counts). Disabled by default.
• ioc: I/O interface driver debug messages (upper layer, verbose). Disabled by default.
• iod: I/O interface driver debug messages (lower layer, verbose). Disabled by default.
• misc: Internal debug messages. Enabled by default.
• rcm: Removable-component manager debug messages. Disabled by default.
• raid: RAID debug messages. Enabled by default.
• cache: Cache debug messages. Enabled by default.
• emp: Enclosure Management Processor debug messages. Enabled by default.
• capi: Internal Configuration API debug messages. Enabled by default.
• mui: Internal service interface debug messages. Enabled by default.
• bkcfg: Internal configuration debug messages. Enabled by default.
• awt: Auto-write-through cache triggers debug messages. Disabled by default.
• res2: Internal debug messages. Disabled by default.
• capi2: Internal Configuration API tracing debug messages. Disabled by default.
• dms: Snapshot feature debug messages. Enabled by default.
• fruid: FRU ID debug messages. Enabled by default.
• resmgr: Reservation Manager debug messages. Disabled by default.
• init: Not used.
• ps: Not used.
• hb: Not used.
Example Show debug log parameters:
# show debug-log-parameters
Debug Log Parameters
--------------------
host: On
disk: On
mem: Off
...
Success: Command completed successfully. (2012-01-18 14:59:52)
Basetypes • debug-log-parameters
• status
See also • set debug-log-parameters