HP MSA 2040 CLI Reference Guide

ManualsBrandsHP ManualsStorageHP MSA 2040 SAS Dual Controller SFF Storage

141

142

143

144

145

146

147

148

149

150

set debug-log-parameters 149

set debug-log-parameters

Description Sets the types of debug messages to include in the Storage Controller debug log. For use by or with

direction from technical support.

Syntax

set debug-log-parameters

message-type

+|- [...]

Parameters

message-type

+|-

One of the following message types, followed by a plus (+) to enable or a minus (-) to disable

inclusion in the log:

• awt: Auto-write-through cache triggers debug messages. Disabled by default.

• bkcfg: Internal configuration debug messages. Enabled by default.

• cache: Cache debug messages. Enabled by default.

• capi: Internal Configuration API debug messages. Enabled by default.

• capi2: Internal Configuration API tracing debug messages. Disabled by default.

• disk: Disk interface debug messages. Enabled by default.

• dms: Snapshot feature debug messages. Enabled by default.

• emp: Enclosure Management Processor debug messages. Enabled by default.

• fo: Failover and recovery debug messages. Enabled by default.

• fruid: FRU ID debug messages. Enabled by default.

• hb: Not used.

• host: Host interface debug messages. Enabled by default.

• init: Not used.

• ioa: I/O interface driver debug messages (standard). Enabled by default.

• iob: I/O interface driver debug messages (resource counts). Disabled by default.

• ioc: I/O interface driver debug messages (upper layer, verbose). Disabled by default.

• iod: I/O interface driver debug messages (lower layer, verbose). Disabled by default.

• mem: Internal memory debug messages. Disabled by default.

• misc: Internal debug messages. Enabled by default.

• msg: Inter-controller message debug messages. Enabled by default.

• mui: Internal service interface debug messages. Enabled by default.

• ps: Not used.

• raid: RAID debug messages. Enabled by default.

• rcm: Removable-component manager debug messages. Disabled by default.

• res2: Internal debug messages. Disabled by default.

• resmgr: Reservation Manager debug messages. Disabled by default.

Example Include RAID and cache messages, exclude EMP messages, and leave other message types

unchanged:

# set debug-log-parameters raid+ cache+ emp-

Success: Command completed successfully. - Debug-log parameters were changed.

(2012-01-21 11:58:38)