HP MSA Events Description Reference Guide (762785-001, March 2014)

36 Event descriptions
243
Info. A new controller enclosure has been detected. This happens when a controller module is moved from one
enclosure to another and the controller detects that the midplane WWN is different from the WWN it has
in its local flash.
Recommended actions
• No action is required.
245
Info. An existing disk channel target device is not responding to SCSI discovery commands.
Recommended actions
• Check the indicated target device for bad hardware or bad cable, then initiate a rescan.
246
Warning The coin battery is not present, is not properly seated, or has reached end-of-life.
The battery provides backup power for the real-time (date/time) clock. In the event of a power failure, the
date and time will revert to 1980-01-01 00:00:00.
Recommended actions
• Replace the controller module that logged this event.
247
Warning The FRU ID SEEPROM for the indicated field replaceable unit (FRU) cannot be read; FRU ID data might not
be programmed.
FRU ID data includes the worldwide name, serial numbers, firmware and hardware versions, branding
information, etc. This event is logged once each time a Storage Controller (SC) is started for each FRU that
is not programmed.
Recommended actions
• Return the FRU to have its FRU ID data reprogrammed.
248
Info. A valid feature license was successfully installed. See event 249 for details about each licensed feature.
Recommended actions
• No action is required.
249
Info. After a valid license is installed, this event is logged for each licensed feature to show the new license
value for that feature. The event specifies whether the feature is licensed, whether the license is temporary,
and whether the temporary license is expired.
Recommended actions
• No action is required.
250
Warning A license could not be installed.
The license is invalid or specifies a feature that is not supported on your product.
Recommended actions
• Review the readme file that came with the license. Verify that you are trying to install the license in the
system that the license was generated for.