HP MSA 2040 User Guide (723983-002, September 2013)

90 SFP option for host ports
The installed SFP should look similar to the position shown in the right detail view.
6. When ready to attach to the host, obtain and connect a qualified cable option to the duplex jack at the
end of the SFP connector.
NOTE: To remove an SFP module, perform the above steps in reverse order.
Verify component operation
View the host port Link Status/Link Activity LED on the controller module face plate. A green LED indicates that
the port is connected and the link is up (see LED descriptions for information about controller module LEDs).