HP MSA 2040 CLI Reference Guide

show ports 267
show ports
Description Shows information about host ports in both controllers. This command shows the same information as
the show host-parameters command.
Syntax
show ports
[detail]
Parameters detail
Optional. This parameter shows additional detail about the port status, including SFP information.
Output Ports
Controller ID and port number
Media
• FC(P): Fibre Channel Point-to-Point
• FC(L): Fibre Channel-Arbitrated Loop (public or private)
• FC(-): Not applicable, as when the port is disconnected
• SAS: Serial Attached SCSI
• iSCSI: Internet SCSI
Target ID
Port WWN or IQN
Status
• Up: The port is cabled and has an I/O link.
• Warning: Not all of the port’s PHYs are up.
• Not Present: The controller module is not installed or is down.
• Disconnected: Either no I/O link is detected or the port is not cabled.
Speed (A)
Actual link speed in Gbit/s. Blank if not applicable.
Speed (C)
Configured host-port link speed. Not shown for SAS.
• FC: Auto, 16Gb, 8Gb, or 4Gb (Gbit/s)
• iSCSI: Auto
• Blank if not applicable
Health
• OK
• Degraded
• Fault
• N/A
Health Reason
If Health is not OK, this field shows the reason for the health state.
Health Recommendation
If Health is not OK, this field shows recommended actions to take to resolve the health issue.
Topo (C)
FC and SAS only. Configured topology.
Lanes Expected
SAS only. If the detail parameter is specified, this field shows the expected number of PHY lanes in
the SAS port.