HP MSA 1040 CLI Reference Guide (762782-001, March 2014)

show host-parameters 241
IP Version
iSCSI only. IPv4 or IPv6.
IP Address
iSCSI only. Assigned port IP address.
Gateway
iSCSI only. For IPv4, gateway IP address for assigned IP address.
Netmask
iSCSI only. For IPv4, subnet mask for assigned IP address.
Default Router
iSCSI only. For IPv6, default router for assigned IP address.
Link-Local Address
iSCSI only. For IPv6, the link-local address that is automatically generated from the MAC address
and assigned to the port.
MAC
iSCSI only. Unique Media Access Control (MAC) hardware address, also called the physical
address.
SFP Status
If the detail parameter is specified, this field shows the SFP status:
• OK
• Not present: No SFP is inserted in this port.
• Not compatible: The SFP in this port is not qualified for use in this system. When this
condition is detected, event 464 is logged.
• Incorrect protocol: The SFP protocol does not match the port protocol. When this
condition is detected, event 464 is logged.
Part Number
If the detail parameter is specified, this field shows the SFP part number.
Supported Speeds
FC only. If the detail parameter is specified, this field shows the link speeds that the SFP supports.
10G Compliance
iSCSI only. If the detail parameter is specified, this field shows the SFP's 10G compliance code, if
supported.
Ethernet Compliance
iSCSI only. If the detail parameter is specified, this field shows the SFP's Ethernet compliance
code, if supported.
Cable Technology
iSCSI only. If the detail parameter is specified, this field shows whether the SFP supports active or
passive cable technology.
Cable Length
iSCSI only. If the detail parameter is specified, this field shows the link length (in meters) that is
supported by the SFP while operating in compliance with applicable standards for the cable type.