HP MPX200 Data Migration Planning Guide

6. Create a host affinity group:
a. In the left pane, click Host Interface Management and then click Allocate Host-Infinity
Group.
b. In the right pane under Select a CA, click the port on which the data migration appliance
WWPN is available (for which host was created in Step 5), and click Set (see
Figure 69 (page 77).)
Figure 69 Allocating a host affinity group
c. In the right pane, select a WWPN visible on the selected registered host WWN and the
Affinity Group to be accessed by the host, and then click Add (see Figure 70 (page 77)).
Figure 70 Mapping LUNs
d. After all needed host WWNs are added, click Set to confirm the additions and map all
LUNs in the affinity group to the data migration.
NOTE: This procedure assumes that the affinity group has already been created for the LUNs
directly presented to the host. The same affinity group also presents these LUNs to the data
migration appliance.
Assigning LUNs from ETERNUS arrays 77