HP MPX200 Data Migration Planning Guide

Figure 67 Creating a host response
5. Create a host (see Figure Figure 68 (page 76)):
a. In the left pane, click Host Interface Management and then click Set Host
WorldWideName(s).
b. In the right pane under Add WNN, create a host by entering the host Name and selecting
the WWN.
c. Select the CA and port to which the data migration appliance is connected.
d. To refresh the visible WWNs and select the correct entry, click Collect.
e. Select the WWPN of the data migration appliance’s FC ports. If the zoned appliance
port is not visible by default, enter the WWPN in the WWN box.
f. Select the Host Response created in Step 4.
g. To apply the changes, click Add.
NOTE: Create a separate host for each WWPN of the data migration appliance, and
then register each FC port of the appliance as a separate host on the array.
Assigning LUNs from ETERNUS arrays 75