HP MPX200 Data Migration Planning Guide

2. In a Web browser, open the NetApp FilerView tool by entering the IP address of the array
controller.
3. Create an initiator group:
a. In the left pane under LUNs, select Initiator Groups and then click Add.
b. Complete the Add Initiator Group area in the right pane (see Figure 45 (page 60)).
Figure 45 Adding Initiator Group
c. In the Group Name box, enter DM_host.
d. For host Type, select FCP.
e. For Operating System, select Microsoft Windows.
f. In the Initiators box, select the WWPN of the data migration appliance FC port.
NOTE: If the zoned data migration appliance port is not visible in the Initiators box,
manually enter the WWPN. Remove all other WWPNs (if any) that do not belong to the
data migration appliance. If more than one VPG is enabled and used, create a separate
initiator group for each virtual port group.
g. At the bottom of the right pane, click Add.
4. Present the LUN:
Assigning LUNs from NetApp Systems 57