HP MPX200 Data Migration Planning Guide

Figure 27 Adding LUNs to DM-Host
9. Refresh the data migration user interface to see if the LUN assignment is reflected properly,
and that the appropriate array entity appears under FC Array. (You may need to click the
Refresh button several times to correctly update the display.)
Assigning LUNs from an EMC Symmetrix DMX-4 array
EMCStorage vendor
Symmetrix DMX-4 arraysArray model
EMC Symmetrix Management ConsoleLUN assignment tool
To assign LUNs:
1. Perform zoning by creating and activating zones containing DMX Fibre Adapter ports and
MPX200 FC ports for data migration.
2. Launch the EMC Symmetrix Management Console.
3. Optional: If the server is running firmware 3.3.0.3 and earlier, you must disable the volume
set addressing bit and enable the SCSI Primary Commands - 2 (SPC-2) protocol version bit.
To set those port properties:
a. Click the Properties Task button, and under Director > Fibre > Port, right-click the port.
b. Select Port and Director Configuration > Set Port Properties.
c. Clear the Volume Set Addressing check box.
d. Select the SPC2 Protocol Version check box.
4. To start the masking wizard, click the Tasks button, and under Operations > Provisioning,
click Provision Storage (Masking Wizard).
5. In the wizard’s right pane under 1. Welcome, click Next to continue.
6. Under 2. Select Symmetrix ID, select the ID, and click Next.
7. Under 3. Select Initiators, follow these steps (see Figure 28 (page 44)):
Assigning LUNs from EMC arrays 43