HP MPX200 Data Migration Planning Guide

2. Using Internet Explorer, open the Navisphere utility using the IP assigned to the storage
controller.
The Enterprise Storage dialog box opens (see Figure 23 (page 39)).
Figure 23 Viewing Enterprise Storage
3. Select the appropriate storage array, right-click the array name, and click Connectivity Status.
4. Select the WWPN associated with the data migration appliance, and then click Register.
5. Complete the Register Initiator Record dialog box (see Figure 24 (page 40)):
a. In the Initiator Type box, click CLARIION Open.
b. For Failover Mode, select 4 (if supported by the array).
c. Under Host Information, select New Host, and enter the values for Host Name and IP
Address.
d. Click OK.
Assigning LUNs from EMC arrays 39