HP MPX200 Data Migration Planning Guide

Figure 3 Selecting LUNs in Storage Management Utility
9. In the Assign Host Access Privileges table, select the DM-Host in the Host WWN - Name list,
and enter the appropriate, planned LUN ID.
10. To accept and save the LUN assignment, click Map it.
11. Refresh the data migration user interface to see if the LUN assignment reflects properly, and
that the appropriate array entity appears under FC Array. (You may need to click the Refresh
button several times to correctly reflect the changes.)
Assigning LUNs from an HP MSA1000/1500 array
HPStorage vendor
MSA 1000/1500 arraysArray model
Storage Navigator Modular user interfaceLUN assignment tool
1. Perform zoning:
a. Connect the FC ports of the data migration appliance to a switch where the storage
controller ports are also logged.
b. Use switch management tools to create a zone DM_Host_MSA1000, and add the WWPN
of the data migration appliance FC ports and storage controller ports in this zone.
c. Save the zoning information and activate the new zoning configuration.
2. Open the Array Configuration Utility.
The Configure Available Device(s) window opens, as shown in Figure 4 (page 24).
Assigning LUNs from HP arrays 23