HP MPX200 Data Migration Planning Guide

To assign LUNs:
1. Perform zoning:
a. Connect the FC ports of the data migration appliance to a switch where the storage
controller ports are also logged.
b. Use switch management tools to create a zone, DM_Host_Emprise5000.
c. In this zone, add the WWPN of the data migration appliance FC ports and storage
controller ports.
d. Save the zoning information and activate the new zoning configuration.
2. In a Web browser, open the Emprise 5000 Management tool by entering the array
management IP address.
3. Click Login, and enter the login user name and password.
4. On the At-A-Glance Status Summary window, click Hosts, and then select create host.
5. Complete the Host Configuration window (see Figure 60 (page 69)):
a. In the Name box, enter a user-defined host name.
b. Under Operating System Type, select Windows.
c. Under Available HBA Ports, select the WWPN, and click Add to move the port number
to the Selected HBA Ports column.
d. Under Available Volumes, select the volume, and click Add to move the volume to the
Selected HBA Ports column.
e. Click Submit to create the host.
The Host Summary Page lists the newly created host in the Host Information table.
Figure 60 Configuring a Host
Assigning LUNs from a Dell Compellent Array 69