HP MPX200 Data Migration Planning Guide

Figure 53 Creating a LUN
d. Verify that the LUN was created successfully, and then click Return to Table.
e. Verify that the LUN is configured correctly.
7. Repeat the preceding step, as needed, to create additional LUNs.
8. To create an initiator group:
a. In the left pane under LUN, click igroup.
b. On the Igroup Table page, click create.
c. Complete the igroup information (see Figure 54 (page 64)):
i. Select the appropriate Vserver Name.
ii. Enter the Igroup Name.
iii. For Protocol, select mixed.
iv. For FCP, select true or leave this field blank.
Because FCP is supported for this igroup, leaving it blank does not make a difference
because the protocol is defined as mixed.
v. For the OS Type, select windows.
vi. For Initiators, enter all host initiators that are applicable; use a comma to separate
the entries.
vii. To complete the igroup, click create.
Assigning LUNs from NetApp Systems 63