Building Disaster Recovery Serviceguard Solutions Using Metrocluster with 3PAR Remote Copy for Linux B.12.00.00

Table 4 Package behavior parameters (continued)
Valid valuesDescriptionParameter name
Default value: No
Zero or value > zero or no timeout.
If Resynchronization wait timeout value is set to zero
and the Remote Copy volume group is in syncing state,
This parameter defines the wait
timeout for Remote Copy volume
group resynchronization. It
Resynchronization
Wait Timeout
Metrocluster software will not wait and returns an error.
The package fails to start on any node in the cluster.
specifies the timeout in minutes to
wait for completion of the Remote
If Resynchronization wait timeout is set to greater than
zero and Remote Copy volume group is in syncing state,
Copy volume group
resynchronization from source to
destination volume before starting
Metrocluster software waits till resynchronization wait
up the package on the
destination.
timeout value for the completion of the synchronization.
If resynchronization wait timeout expires and
synchronization is still in progress, the package fails to
start on any node in the cluster.
If Resynchronization wait timeout is set to No Timeout,
then the package startup waits until either the
resynchronization completes or fails.
Default value: Zero
An Integer value greater than zero.
Default value: 250
This parameter specifies the wait
time in seconds for the remote
Periodic Link Down
Timeout
copy volume group to stop when
the remote copy link is down.
Figure 6 Package Behavior Parameters
6. To set Notification Preferences choose Others option and then select one or more notification
types.
26 Configuring an application in a Metrocluster environment