Building Disaster Recovery Serviceguard Solutions Using Metrocluster with 3PAR Remote Copy for Linux B.12.00.00

Table 2 Identification parameters
Valid valuesDescriptionParameter name
Any name, up to a maximum of 39
characters, that:
Any name that is unique among package
names in the selected cluster.
Package Name
• Starts and ends with an alphanumeric
character
• Otherwise contains only alphanumeric
characters or dot (.) or dash (-) or an
underscore (_)
Can contain a maximum of 80 characters.
Default value: Serviceguard Package
A brief description of the application
managed by the package.
Package Description
NAThe toolkit with which the package is
configured. For more information on toolkits.
Select Toolkit
NASelect the replication type to be used with the
package configuration. This parameter is
Select Replication
Type
applicable only in a Metrocluster or XDC
cluster.
Failover or Multinode
Default value: Failover
Different package types.Type
Select the required nodes on which the package must run from Package Startup
Parameters+Node Selection and Order subsection.
NOTE: By default, Select all Nodes check box is selected. To select the nodes you require
clear the check box and then select the required nodes. If any toolkit is selected, only the
nodes on which the toolkit is configured will be listed.
Figure 3 Create Package
3. In the Identification Parameters subsection, set Select Replication Type as 3PAR (Array Based).
Configuring Metrocluster Packages 23