Building Disaster Recovery Serviceguard Solutions Using Metrocluster with Continuous Access for P9000 and XP A.11.00

Ensure that the map files are copied to all the nodes in the target disk site.
3. On the target disk site, import the VGs on all the systems that will run the Serviceguard complex
workload package.
# vgimport -s -m <map_file_name> <vg_name>
Configure the identical complex workload stack at the recovery site
The complex workload must be packaged as Serviceguard MNP packages. This step creates the
complex workload stack at the target disk site that is configured to be managed by the Site Controller
Package. For more information about configuring the complex workload stack, see the section
“Configuring the complex workload stack at the source disk site” (page 39).
Halting the complex workload on the recovery site
You must halt the complex workload stack on the recovery site so that it can be restarted at the
source disk site. Halt all the packages of the complex workload using the cmhaltpkg command.
When using CVM or CFS, run the vxdg deport command to deport the disk groups at the nodes
in the replication target disk.
After halting the complex workload on the recovery site, you must re-synchronize the target disk
from the source disk for the replication that was split using the procedures listed in the section.
“Preparing the replicated disk at the target disk site” (page 40).
Configuring the Site Controller package for the complex workload
The Site Controller package and the Site Safety Latch for the disaster tolerant complex workload
are the final components to be configured.
Configuring the Site Controller package using Serviceguard Manager
To configure a Site Controller package using Serviceguard Manager:
1. Access one of the node’s System Management Home Page at http://<nodename>:2301.
Log in using the root user credentials of the node.
2. Click Tools. If Serviceguard is installed, one of the widgets will have Serviceguard as an
option. Click the ‘Serviceguard Manager’ link within the widget.
3. On the Cluster’s Home Page, click the Configuration Tab, and select the Create a Site Controller
Package option.
42 Configuring complex workloads using SADTA