Building Disaster Recovery Serviceguard Solutions Using Metrocluster with 3PAR Remote Copy for Linux B.12.00.00

Figure 4 Select Replication Type
4. Enter the 3PAR parameters in the 3PAR Replication Parameters section. Table 3 (page 24)
describes 3PAR replication parameters.
Table 3 3PAR replication parameters
DescriptionParameter name
The directory is checked for presence of FORCEFLAG, which
is used at time where package is not allowed to startup
Metrocluster Package Configuration Directory
automatically, but you want to start the package forcibly
after understanding the risks.
Sites in a Metrocluster environment.
NOTE: The Metrocluster environment may also be
configured without any sites. If there are no sites present,
the user must map the replication parameters logically based
on the roles.
Data Center 1 and Data Center 2
NOTE: Data Center 1 and Data Center 2 are
application-specific roles of a site.
Enter the desired node name and then click add to use that
node as part of the cluster.
Node name
The DNS (Domain Name Server) resolvable name or IP
address of the 3PAR storage system.
NOTE: Data Center 1 must not be same as Data Center
2.
Storage System Name
The user on the 3PAR storage system.
Metrocluster executes the Remote Copy commands on
storage system through cli using the specified user. This
Storage System User
user must have access to perform the Remote Copy
operations on the site.
24 Configuring an application in a Metrocluster environment