HP-UX Virtual Partitions 6.0 Release Notes

5 Installing HP-UX Virtual Partitions v6.0
Installation requirements
You can create virtual partitions on the VSP after installing the HP-UX Virtual Partitions v6.0 BB068AA
bundle and VirtualBase from a distribution media. Table 3 (page 13) lists the software products
required to be installed on the VSP and on the vPars.
Table 3 Software required to be installed on VSP and vPar OS
vPar OSVSP
HP-UX 11i v3 September 2011 (AR1109) (any OE)HP-UX 11i v3 September 2011 (AR1109) (Base OE,
VSE-OE, or DC-OE)
VirtualBaseBB068AA, VirtualBase
Following OS patch:
• PHKL_42464
Following OS patch:
• PHKL_42464
Following Serviceguard patches (applicable only if Serviceguard
is installed):
Following Serviceguard patches are not required for
VSP:
• PHSS_42136• PHSS_42136
• •PHSS_42137 PHSS_42137
NOTE: The vPars 6.0 bundle BB068AA does not include the HP Integrity Virtual Server Manager
(vPars v6.0 GUI) software. HP Integrity Virtual Server Manager is a separate ISU (Independent
Software Unit) bundle. You can download HP Integrity Virtual Server Manager from the HP Software
Depot at http://www.software.hp.com.
Table 4 Recommended patches and updates for VxVM and System Fault Management
System Fault ManagementVxVM
Update System Fault Management software to:If using VxVM 5.0.1 install PHKL_42649, PHCO_4267
and PHCO_42648 patches.
• ProviderSvcsBase C.06.00.05.02 Provider Services
Base
• SysFaultMgmt C.07.04.07.03 HPUX System Fault
Management
NOTE: Both ProviderSvcsBase and SysFaultMgmt are included in the WBEM Management bundle
— https://h20392.www2.hp.com/portal/swdepot/displayProductInfo.do?
productNumber=WBEMMgmtBundle
Installing HP-UX Virtual Partitions v6.0
vPars v6.0 is packaged in a Software Depot (SD) and installed in the VSP using the swinstall
command. The minimum Operating Environment (OE) version is HP-UX 11.31 September 2011
update (AR1109) for both the VSP and vPars. Once vPars are created using either the GUI or the
CLI, the deployment of HP-UX OEs can be performed by an Ignite-UX server using specific entries
in /etc/bootptab file or using a Direct Boot Profile (dbprofile) entry in the EFI of the vPar.
To install HP-UX Virtual Partitions v6.0 software:
1. Install HP-UX 1109 (Base-OE, VSE-OE, or DC-OE) and the required patches on the VSP. See
the vPars v6.0 release notes for the required patches. Go to the next step after HP-UX boots.
2. Install Virtual Partition Software products BB068AA and VirtualBase on the VSP.
swinstall –x autoreboot=true –s <VirtualPartitionDepot> \
Installation requirements 13