HP Insight Dynamics- VSE for ProLiant Installation and Configuration Guide

NOTE: In some versions of HP-UX Bastille, the MANDMZ.config file might be located in a subdirectory
under /etc/opt/sec_mgmt/bastille/.
2. Add the following rules to the top of the file /etc/opt/sec_mgmt/bastille/ipf.customrules.
NOTE: Lines shown ending in “\” should be combined with the following line and entered as a single
line.
# Custom HP SIM Managed System firewall rules # Allow
ping pass in quick proto icmp from any to any icmp-type 8 \ keep state
# Global Workload Manager uses port 9617 to # communicate with the
CMS pass in quick proto tcp from any to any port = 9617 \ flags S
keep state keep frags
3. Run the Bastille configuration engine by entering the following command:
# /opt/sec_mgmt/bastille/bin/bastille -b
Performing post-installation configuration tasks
This section describes the procedures for performing postinstallation configuration tasks for HP Insight Software
suites.
IMPORTANT: The Getting Started screen appears after the HP Insight Software suites are installed. The
information on this screen assists you in performing postinstallation configuration tasks.
Postinstallation configuration tasks include the following:
• Checking for software updates
• Downloading HP Version Control Repository Manager automatic updates
• Performing HP SIM initial setup tasks
• Configuring the HP Service Essentials Remote Support Pack
• Performing HP Virtual Connect Enterprise Manager postinstallation configuration tasks
• Performing HP Vulnerability and Patch Management postinstallation configuration tasks
• Performing Insight Power Manager postinstallation configuration tasks
• Configuring domain accounts for HP Rapid Deployment Pack
• Deploying the VMM Agent to set up virtual machine hosts for Virtual Machine Management Pack
• Configuring VMWare VirtualCenter
The Software Update utility connects to the HP website to look for new releases of the components installed
by HP Insight Software. If newer versions of installed components are available, the utility provides links to
the downloads, component status, version numbers, and release dates. The Software Update utility also
provides update notifications for new DVDs. Access the links to download, and manually install the updates.
Each week, the Software Update utility schedules a task to check for HP Insight Software component updates.
If updates or new components are available, then an event with component download information is logged
in the HP SIM events list.
To check for software updates or to modify the scheduled task, perform the following steps.
1. On the Software Updates window, select Tools→Insight Software→Software Updates.
2. (Optional) If you use a proxy server, select the appropriate checkboxes, and then enter your configuration
information. If the proxy server requires authentication, select the appropriate checkbox, and then enter
your user credentials. Click Apply. You enter this information only once.
Performing post-installation configuration tasks 29