HP Matrix Operating Environment 7.1 Installation and Configuration Guide for Provisioning with Virtual Resources

2. Turn off the User Account Control.
NOTE: You will need to restart Windows after making this change.
a. For Windows 2008 SP2:
i. Click Start and then click Control Panel.
ii. In Control Panel, click User Accounts.
iii. In the User Accounts window, click Turn User Account Control on or off.
iv. Clear the User Account Control (UAC) to help protect your computer checkbox.
v. Click OK.
vi. Click Restart Now.
b. For Windows Server 2008 R2 or Windows 2008 R2 SP1:
i. Click Start→Control Panel.
ii. In Control Panel, if your view is set to display by Category, click System and Security
and then click Change User Account Control Settings.
iii. Drag the slider to Never notify.
iv. Click OK.
v. Click Restart Now.
Installing an SPP
For a CMS running on an HP server, you must install a compatible HP Service Pack for ProLiant
(SPP) and finish any network configuration that is required to communicate with your hypervisor
hosts and other managed nodes. Install both firmware updates and the online components for
Windows using the HP Smart Update Manager. The installation of the SPP online components for
Windows requires the SNMP Services feature.
If your CMS is running in a virtual machine, there is no need to install the SPP. The SPP does not
run on a guest operating system environment regardless of the hypervisor.
Installing an SPP 17